隔热反射节能中间体（新一代 节能产品）/Heat insulation reflective energy-saving intermediates (a new generation of environmentally friendly energy-saving products)

　　隔热反射节能中间体(新一代 节能产品)

　　III. Heat insulation reflective energy-saving intermediates (a new generation of environmentally friendly energy-saving products)

　　产品介绍:

　　隔热反射节能中间体是采用 合成树脂为基料，以功能性的耐热粉、与陶瓷空心玻璃微球及特种助剂聚合而成，具有红外反射比和半球发射率的涂料，两大功效保证了涂料在物体上能降温，确保了物体内部空间能保持 恒温的状态，从而实现节省能耗的目标，达成节能 的效果

　　Product introduction:

　　Heat insulation and reflection energy-saving intermediate is the use of high-quality synthetic resin as the base material, with functional heat-resistant powder, and ceramic hollow glass microspheres and special additives polymerization, with infrared reflection ratio and hemispherical emissivity of the coating, two effects to ensure that the coating on the object can be cooled, to ensure that the object can maintain a lasting constant temperature in the internal space, so as to achieve the goal of saving energy consumption, to achieve the effect of energy saving and environmental protection.

　　产品成分：

　　 水性合成树脂、耐热粉、空心玻璃微珠及特种助剂等原材料

　　Product composition:

　　High quality water-based synthetic resin, heat resistant powder, hollow glass beads and special additives and other raw materials.

　　施工条件：

　　基层应坚实，墙面孔洞及墙体空鼓应处理平整、硅酸钙板、石膏板、模板与墙体之间或板与板的接缝处应先进行接缝处理，表面无浮灰、污物、粉化、起皮(若原墙面基层是批刮过建筑胶水腻子层、石膏粉、纸筋石灰， 全部铲除干净)

　　Construction conditions:

　　The substrate should be solid, wall holes and wall drums should be treated smoothly, the joints between calcium silicate board, gypsum board, formwork and wall or board and board should be treated first, the surface should be free of floating ash, dirt, chalking and peeling (if the original wall base is scraped with construction glue putty layer, gypsum powder, paper reinforced lime, all must be eradicated clean).

　　使用范围：

　　本产品适用于所有的内墙墙体表面

　　Scope of use:

　　This product is suitable for all internal wall surfaces.

　　执行标准：

　　BD/T25261-2018 《建筑用反射隔热涂料标准》

　　JG134-2010 《夏热冬冷地区居住建筑节能设计标准》

　　①抗菌 ②反射隔热 ③ 节能 ④抗碱

　　⑤耐水、防潮 ⑥ ⑦净味 ⑧速干

　　Implementation standard:

　　BD/T25261-2018 Standard for Reflective Thermal Insulation Coating for Buildings

　　JG134-2010 Energy-saving Design Standard for Residential Buildings in Hot Summer and Cold Winter Areas

　　①Anti-bacterial

　　②Reflective heat insulation

　　③Environmental protection and energy saving

　　④Alkali resistance

　　⑤Water and moisture resistant

　　⑥Anti-mould

　　⑧ Environmental friendly

　　⑧Quick drying

　　产品中心—产品对比：

　　性能分类负离子抗菌防火无机涂料普通乳胶漆

　　成膜物质硅酸盐、硅溶胶、乳液乳液

　　附着力负离子 与矿物质墙面(含石灰质封面)发生化学结合并可渗入墙面0.5—1mm,形成防酸的硅化石负离子表层机械式表面粘结，粘结力依其中的聚脂粘结物的比率而不同

　　胀缩系数与矿物质墙面的胀缩系数相同，故能避免因受热而产生的龟裂胀缩系数大于墻壁面的10—20倍，因而极易导致因受热而产生的涂料龟裂脱落。

　　透水率>400<50

　　抗苔藓，藻类滋长因强碱性(不含营养)故苔藓，藻类之微菌不能滋长有机成分助微菌类滋生，造成墻身污化

　　气味不含有乙二醇、成膜助剂、防腐剂含有乙二醇、成膜助剂、防腐剂

　　静电对墻身污染的影响不产生静电，故不会挂灰尘;同时因具可 性，能使墻身内水分迅速蒸发，保持墻身干爽清洁会有静电产生，容易吸收尘埃，

　　特别是在深层及墻身之龟裂隙隙造成污染

　　涂料寿命比较在一般环境下，

　　其寿命较有机乳胶性涂料长了3—5倍，

　　在极恶劣的天气或环境下

　　可比乳胶性涂料长5—10倍2—3年后就会出现：

　　生苔藓，“吐白”，褪色，

　　堆积污物，以至脱落，5年后褪色，2年后受污染严重甚至会脱落

　　清洁保养一般墻身的污染物可用高压水枪来喷射清洁，坚固的则可用细砂纸

　　或一般酸性清洁剂来清洗。( 无机瓷化漆)

　　不能用高压水枪来清洗

　　(因会导致涂料脱落和剥落等种种问题)

　　 的办法是重新粉刷

　　防火阻燃可达到 防火，阻燃，不产生有害气体一般都不阻燃，并产生有害气体

　　Product Centre - Product Comparison

　　Performance classificationAnionic antibacterial fireproof inorganic coatingsOrdinary emulsion paints

　　Film-forming substancesSilicates, silica sols, emulsionsEmulsions

　　AdhesionThe negative ions are permanently chemically bonded to the mineral wall (with limestone cover) and can penetrate 0.5-1mm into the wall, forming an acid-proof silica negative ion surface layer.Mechanical surface bonding, the bonding force varies according to the ratio of the polyester binder in it.

　　Coefficient of expansion and contractionThe coefficient of expansion and contraction is the same as that of mineral walls, so it prevents cracking due to heat.The coefficient of expansion and contraction is 10-20 times greater than that of the wall surface, which makes it highly susceptible to cracking and peeling of the paint due to heat.

　　Water permeability>400<50

　　Resistance to moss and algae growthNo moss, algae or microflora can grow because of the strong alkalinity (no nutrients)Organic components encourage the growth of microflora and cause staining of the wall.

　　OdourDoes not contain glycols, film-forming agents, preservatives.Contains ethylene glycol, film-forming agents, preservatives.

　　Effect of static electricity on wall contaminationDoes not produce static electricity, so it does not hang dust; at the same time it is breathable, so that the water in the wall evaporates quickly, keeping it dry and clean.Static electricity is generated and dust is easily absorbed, causing contamination especially in the deeper layers and in the cracks of the wall.

　　Comparison of paint lifeUnder normal conditions, it lasts 3-5 times longer than organic latex paints, and 5-10 times longer than latex paints in extremely difficult weather or conditions.After 2-3 years, it will appear: moss, "white", fading, accumulation of dirt and even peeling, after 5 years fading, after 2 years it will be heavily contaminated and even peeling.

　　Cleaning and maintenanceContaminants on the general wall can be cleaned by spraying with a high-pressure water jet, while solids can be cleaned with fine sandpaper or general acidic cleaners. (High-grade inorganic enamelling paint).It cannot be cleaned with a high-pressure water gun (as it will cause problems such as peeling and flaking paint) and the only way is to repaint.

　　Fire retardantIt can achieve class A fire resistance, flame retardant and does not produce harmful gases.They are generally not flame retardant and produce harmful gases.